23/11/2007, 16:27:37
Hi
Ok ill try that again..but its not a connector problem, since in my
board i have several other eib modules
I already disconnect then all, and changed the connections (using the
connector from the other modules) letting only the ts223 in bus and it
still kills the line...
If someone can get me schematics from EIB modules i could check whats
wrong.
Maybe its just the BIM11* that is dead (i think i have the schematic
for that) or some relais etc etc went dead short-cutting the input.
I dont know if theres any protection, or any circuit before the 29V
arrives to BIM chip. (im always talking inside the module, cause bus
power supply is protected
)
Did someone ever saw a module inside?
Schematics need...
please help
Goahead
Ok ill try that again..but its not a connector problem, since in my
board i have several other eib modules
I already disconnect then all, and changed the connections (using the
connector from the other modules) letting only the ts223 in bus and it
still kills the line...
If someone can get me schematics from EIB modules i could check whats
wrong.
Maybe its just the BIM11* that is dead (i think i have the schematic
for that) or some relais etc etc went dead short-cutting the input.
I dont know if theres any protection, or any circuit before the 29V
arrives to BIM chip. (im always talking inside the module, cause bus
power supply is protected
)Did someone ever saw a module inside?
Schematics need...
please help
Goahead